Determination of Optimum Test Parameter Level Ranges for Machining Processes
Yazarlar (6)
Mohamed Almokhtar K. Alabayed Karabük Üniversitesi, Türkiye
Safa Aisa Sasi Alghatous Karabük Üniversitesi, Türkiye
Cevat Ozarpa Ankara Medipol University, Türkiye
Dr. Öğr. Üyesi Şeyma KORKMAZ Kırşehir Ahi Evran Üniversitesi, Türkiye
M. Huseyin Cetin
Konya Technical University, Türkiye
Konya Technical University, Türkiye
Ibrahim Salem A. Basher Sirte University, Libya
| Makale Türü |
Özgün Makale
(SCOPUS dergilerinde yayınlanan tam makale)
|
||
| Dergi Adı | Engineering Technology and Applied Science Research | ||
| Dergi ISSN | 2241-4487 Dergi Bilgileri (2024) | ||
| Dergi Tarandığı Indeksler | ESCI | ||
| Makale Dili | Türkçe | Basım Tarihi | 06-2024 |
| Cilt / Sayı / Sayfa | 14 / 3 / 14533–14538 | DOI | 10.48084/etasr.7365 |
| Makale Linki | http://dx.doi.org/10.48084/etasr.7365 | ||
| UAK Araştırma Alanları |
Makine Mühendisliği
|
||
| Özet |
| In this study, the ideal experimental design planning for the machining process was investigated. Two experimental designs were created by differentiating the parameter levels considered in the drilling process of stainless-steel. Close and far-level designs were obtained by creating 20% and 40% differences between the parameter levels. In the experimental system prepared according to the Taguchi method, surface roughness and cutting forces were measured as the output parameters. The results were analyzed statistically by optimization, analysis of variance and correlation analysis, and visually by chip morphology examination. According to the findings, it was determined that a 20% difference between the parameter levels was more appropriate in terms of experimental system stability, statistical data significance, and chip morphology. |
| Anahtar Kelimeler |
| cutting force | drilling | parameter level range | statistical analysis | surface roughness |
BM Sürdürülebilir Kalkınma Amaçları
| Atıf Sayıları | |
| Scopus | 1 |
| Google Scholar | 1 |